Installation

Plug the dongle to a USB port and execute the “Metus NDI Multiview” and please follow the instructions.

Please click the Next button and continue.

Open

To operate Metus NDI Multiview, configure the Web server settings during installation. Specify the IP address and port of your Web server at this stage.
This IP is going to be used by the Metus NDI Web Controller to connect. Make sure the Port you enter is not used by any other application and please ensure that you enter a valid IP address and port number that is active on the system where you have installed the application.

Open

Next step is choosing where to install Metus NDI Multiview. If there is no specific folder that user want to install, it’s recommended to leave the default folder as it is.

In this step progress of installing can be observed. By clicking “Next” button after installing progress finishes, a new window will be appeared.

And finally when installation is completed a pop up window will inform that Metus NDI Multiview has been successfully installed.