Metus NDI Multiview Adding and Removing Source
\uD83D\uDCD8 Adding and Removing Source:
| Info |
|---|
Metus Multiview automatically scans the NDI sources on the network and lists them on the source panel. To publish these sources on the Multiviewer output screen, follow the steps below. |
...
Select a source from the source list.
Drag and drop the chosen source onto the desired schema in the multiviewer layout for output.
The selected source will be published as
...
an output.
| Info |
|---|
Although displaying all layers on a single monitor is feasible, you can output the video preview of a selected layer to a corresponding monitor attached to the graphics card, in full-screen mode. Please refer to the figure below. |
Clicking the "Send to Monitor" icon within the selected layer allows you to publish the chosen source
...
on one of the monitors listed that is attached to the graphics card.
You can use the Record button to capture the published screen.
You can enable or disable Audio listening option.
The encoder settings can be customized individually by accessing the gear button within the Encoder. Configurations for each encoder can be adjusted independently.
Clicking the gear button in the encoder settings menu allows you to customize or set specific settings for each individual encoder.
1. General Settings > By clicking Select button you have the option to change the source of the encoder at any time or disconnect from the source.
2. Replacement > You can readjust the placement position of the selected source and readjust the output monitor.
3. You can record the chosen source with customized settings.
4. Customize > You can customize the source settings using the following options.
Removing Source > To remove the source you can simply click on the Disconnect button.
