...
Choose correct Port (in this case, COM3) and click OK. You will see the name of the VTR (in this case, 3918) appears on the Tape Record display.
2 Add an Encoder
Add File Source as Video Source and select a file as shown on the figure below. The user can choose any media file just to create the file source as an encoder, means selected file does not have to be the file to be printed to VTR. Simply do the same to add File Source as Audio Source.
3 Define Decklink as the printer
Select Decklink - Decklink Output from Profiles presets and click 'OK'.
Note that, more than one Decklink board may be connected to INGEST workstation; in that case the user will select the related Decklink Video Renderer from Select Source window as shown on the figure below. If more than one Decklink cards are connected to PC, then the renderers will be listed as Decklink Video Renderer, Decklink Video Renderer (2) and so on.
Finally, you must select the related Video Output from the Output tab as shown on the figure below.
3 Set Your Playlist
...
To add media to be printed to VTR, you can click to '+' button and select the media file as shown on the figure below. See the path of the file appears in Tape Record tab after adding.
Then, you can set the duration of the record by adjusting File In and File Out parameters. On the figure shown below, the user will print only the first 5 minutes of the media file to VTR and printing will start with the Start Position set to 1 min.
On the figure shown below, the user sets 5 mins. to Start TC , which is the timecode counter start point for the first frame of the video source. The duration of the video source is 4 mins.
4 Final Settings
...